NYC/NJ Turntable Setup Expert


Good Evening All,

I am looking to purchase a new cartridge (targeting Hana SH or MH) for my VPI Aries I turntable. Ultimately, however,  I would like to commission an expert to come to my home and help setup the cartridge/TT. Does anybody have any recommendations (outside of Fremer, $500 for a setup is outside my budget) in the NYC/NJ-metro area that provides this service, perhaps a dealer, and is good at it? 

Thanks!
scorndefeat

Showing 1 response by millercarbon

Spend a few bucks on a cartridge scale. The $20 Shure is fine. Spend $50 on the MoFi Geo-Disk. Read the directions. Follow the directions. Learn. Save. What's not to like?
Seriously, its not hard.

Watch Fremer on YouTube. Except when he goes into all the gadgets he loves but you don't need. Watch mostly because Fremer is fun, and also to see how easy it is, and also because this is one of those things that's a whole lot easier to follow watching someone do it vs reading about it.
Main points- do this on a nice clean well lit kitchen table, with plenty of time (an hour at least, even though it will take maybe half that) and with a few little tricks even Fremer doesn't know (but I sure do!)
Tape the platter so it doesn't move. Place a Q-tip on the record. Position the Q-tip between the cartridge and the platter. This will prevent the cartridge from going too low, eliminating the #1 risk of damage.
That's it. Watch Fremer. He has at least 2 full videos on YouTube. Its just not that hard. He makes that point over and over again.