NUFORCE AMPS FOR PASSIVE SUBWOOFERS


I need a pair of small mono amps that I can hide behind my subs(Kinergetics SW-800), I can leave on, don't get hot and have alot of power to drive and control the six 10" woofers per side. Are the Nuforce up to the challange or should I be looking elsewhere?! I would like at least 300watts or better per channel. The subs a 4ohm. Thanks for any info!
ptheo

Showing 1 response by undertow

The K1 Destroys the Nuforce, no joke... It is a pro unit, no fan, barely any heat, and can be driven way beyond the input voltage and has a 28 db setting, 1.4 volt setting, and bridge Switch...Can take full boosted output of like 20 db gain from a parametric or other processor, especially pro units that can do this. I picked one up for 400 used, it is a very similar to digital design, I swear I did see a module inside the Crown that had ICE written on it, but not to mention it only idols pulling 12 watts from the wall, it is All U.S.A built, and dead silent, ZERO FM interferance problems, Zero Hum, Zero HISS... On 98 DB efficient drivers.. Now I have heard the nuforce standard versions, they will not hold up to the crown.. But the Crown has a Huge Torroid and Way Higher Peak power for way less money, and again it is a pro unit designed for a good beating, has built in limiters, and Has Individule Detent Gain Controls for each channel so you can taylor to your liking. Only problem with them is the Binding posts are rediculously close on the back and a little tuff to hook up without using a Quarter to tighten them up, and you will need to have RCA to Balanced cables if you are running RCA.. You will not hear the Crown K1 Click, Pop, or Hum when Turned on, it will not Dim the lights etc... Not to say the nuforce will, just giving an Idea of the quality in this unit. By the way the Crowns are Stereo, but if you must have mono blocks to seperate across the room, than well you need 2, otherwise go with the nuforce, but seems to be a waste of money for Subwoofer bass.