Nordost ECO 3 Static Inhibitor anyone?
Hi Glen, I hav'nt used it yet myself but I am planning to. If I remember correctly it is ok to use on the cd itself, but I believe you are supposed to apply it to the label side. I also remember reading you can spray it directly on the transport as well. Yes it does work on the cabels too. Hope this helps. as always.....good luck!!! Vader |
Thanks guys here's the response from Vin at Nordost Dear Glen, Thank you for your inquiry. Actually, one of the demonstrations we do at trade shows is to spray a CD with ECO3 and show the audience the improvement it makes. It is quite effective in lowering the noise floor and improving the dynamics of the system. When you use it on a CD you should apply it only to the label side. Even though it is water based, it will leave a slight film over many uses which is not a good thing on the information side of your disc. I hope this is helpful. Best regards, Vin Garino Nordost -----Original Message----- |
Bob, tell that to Madrigal, they use it ALL the time. All my customers take my advise on Rubbing Alcohol, and was amazed. blows away endust and it alot cheaper, cleans better, preserves and protects. i would advise people in this forum to try and will see what i mean. for your cables eco3 the ticket! |
bob_bundus, have you try on a vinyle LP ? If you spray on speaker cable can we spray also on interconnect ? |
Been using this stuff since the 80's http://www.brillianize.com Spidey senses telling me it does the same thing, for a hell of a lot less. Does a fabulous job on my Nordost stuff. I can see the musical notes appear from the speakers much clearer, after a wipe down. I don't know about its use on a CD. |
