Noise from tweeter


I am using Aerial 7B's drivin by a ML 333.5 amp from a Theta Casa Nova and a Sony DVP 7700, I am using Kimber Monacle XL to Aerial's, Kimber Hero interconnects from Sony and Kimber Hero balanced to ML. When I put my ear to the tweeters I can here noise, even when evrything but the amp is turned off. The amp is plugged into a dedicated 20 amp circuit. Note: I had the same problem with the Classe' CA 400 I was using before. Thanks in advance, Henry
goose89

Showing 1 response by sugarbrie

There is going to be some noise (HISS sound); it won't be dead quiet. If you have to put your ear right up to the tweeter to hear the noise, then it might be normal....

Now if what you hear is a low HUM and not a HISS, then it could be a "ground loop hum" problem. It can be fixed by removing the electrical AC ground on the component causing the problem (I assume the amplifier in your case). The way to test it (and fix it quickly) is to put a "cheater plug" on the AC power cord of your amp (or the component causing the hum). A "cheater plug" is one of those adapters that allow you to plug a 3 prong AC cord into a AC socket without the third ground input.

Assuming it is a ground loop hum and you do not want to use a cheater plug with a high end power cord as a permanent solution; you could take the power cord plug apart and disconnect the ground wire. If you are not comfortable with this, some audio power cord makers will make you a custom cord with the ground disconnected.