Nitty Gritty 1.5Fi vs. VPI HW16.5vs. Okki Nokki


I've been back into analog for about 2 years. As I've resurrected a lot of old vinyl and purchased a lot of used vinyl (Half Price Books, lot sales on Audiogon and other sites, etc.), a record cleaning system better than my present Spin-Clean has become a necessity.

Spin-Clean does a decent job but, with some but by no means all of my records, there is a lot of surface noise that is left behind. I presume that this is due to residue that results from the surface tension of the droplets of fluid left behind after the record is dried (either by air or by using the supplied cloths), or, less likely, the attraction of microscopic particles to the [still slightly wet] record surface as it dries, and which cannot be removed by pre-play record cleaners (i.e., Audioquest brush, Discwasher, etc.).

Why surface noise is audible on some records more than others could be due to many things--the cut and modulations of the groove, mold release chemicals, etc., etc. Also, it can vary from one side to the other and from one track to the next in the same record.

I'll mention that I only use the Spin-Clean fluid, and mix it with distilled water in the proportion recommended by Spin-Clean.

All of which I mention because it speaks to the necessity for some form of vacuum cleaning.

I'd like to open up to the forum re any preferences in the above named field of machines (or any others which any forum contributor deigns to recommend).

Also, could there also be a cheap'n'cheerful alternative to any of the above, such as the KAB record cleaner and a canister vacuum, used in conjunction with the Spin-Clean? I know I'd have to spin the record manually and deal with an external vacuum source, but at a third of the price, it merits serious consideration.

In any event, I welcome the forum's esteemed opinions.

Thanks, John
128x128distant_replay

Showing 1 response by nax

You stated that on some of your records that you clean with Spin-Clean but by no means all of them there is surface noise left behind. If there is noise left behind then either the records that noisy after cleaning either have needle damage done to them or perhaps they where cleaned prior to the Spin-Clean with a cleaner that left a coating of something on the disc that the Spin-Clean was unable to remove in one cleaning. It is also very important to have multiple drying cloths on hand in order to thoroughly dry the records after cleaning and to make sure that you are using the proper number of caps of fluid per bath,
4 oz bottle uses Three Caps Full of Fluid Per Bath and the 32OZ bottle only uses one. There are also a lot of people who use the Spin-Clean for Cleaning and a Vacuum unit to dry because most of the Vacuum units use an alcohol based cleaning solution which can be detrimental to the vinyl.