2. speakers
  3. 1279836023

New Magnepan 1.7 Owner

Hi guys. I'm the proud owner of really, my first pair of Magneplanar speakers (I only spent a few days with the MG12 and decided to upgrade). I picked up my 1.7's yesterday in the aluminum trim. I will post a review soon.

Anyway, I wanted to ask a few questions about the simplest of upgrades, replacing the tweeter jumpers and fuses.

I need recommendations on fuses and most importantly, where I can purchase them. Also, I don't know much about electronics but I think the value of the fuse is the same as the 1.6 correct? 4A Large Fast Blow?

Also, tweeter jumpers. I have some Audioquest Banana connectors and some Audioquest speaker wire, should I remove the stock jumpers and replace them?

Thanks guys, much appreciated.
audiocr381ve

Showing 2 responses by magfan

magfan
1,583 posts
 
I'd wait until the speakers were run in before making ANY changes.
Do your initial setup than wait for maybe 20 or 30 playing hours.
readjust. Repeat until 100->200 hours or the urge to readjust passes.
Poster above likes 300 hours. Mine were about 80% at 50 or 60 hours with the balance over the next 100 or so. No beef with waiting longer, though.

THAN bridge the fuse out of the circuit and install the jumper of your choice.

I even ended up tweeters IN with toe to cross just behind my listening position. This gives a large sweet spot and good image. I also have the Mylar to the BACK not the front as issued by Magnepan. Sweet.
magfan
1,583 posts
 
The tweeters can go inside OR outside.
You can even flip 'em backwards, so the mylar is to the back and the magnet assembly is to the front. I have mine that way now, and glad I did.

But, don't mess with anything until you have a 'baseline' established.
More to discover