Need Maggie MG-2C help....

Well I hooked up the Aragon MKII and the speakers sound great. So the extra power really helped. This is the way I imagined they would play from the start. Now I'll look into some better jumpers as a few of you have suggested. Regards, Danton

Thanks for the responses! The SA-100 is gone and I'm going to give the Aragon 4004 mkII a try. It should have the power I need. As soon as I get it I'll post the outcome. Regards,Danton

With all respect to the previous post, Maggies are notoriously inefficient and, the larger the surface area, the more energy it will take to drive them.

There is no direct relationship between speaker impedence and it's efficiency. If there were, all speakers of a given impedence would have the same efficiency rating (measured in dB @ 1 watt @ 1 meter).

I happen to have a pair of 12's and tried the SA-100, but had a similar experience to your's in that the sound was weak and turning up the gain only over-drove the amp which resulted in some harsh-sounding mid-bass/mid-range and sometimes strident highs. The SA-20 cleared that up.

Maggies are very revealing speakers and you need a fair amount of high quality power to drive them well. Don't discount that there might be a problem with the speaker as Fdriver suggests, but first borrow some more power (around 200 wpc)and see if that solves the problem.

Let us know how it turns out.....

Regards
Jim

Uh, Danton.

The MG-2C does NOT have any ribbons. It has two standard planar drivers.

It has a pure 5 ohm load, with little deviation. Hence, it should be very easy to drive. You do not need any more power.

However, there could be a problem with the speaker diaphram itself. Have you considered getting them checked out by the factory or dealer?

I agree that more clean power the better. Regarding your speaker placement and acoustics, check the DIY asylum for projects to treat your Maggies. Some worthwhile to mention are the DIY Argent Room Lens project on Jon Risch’s website. Also obtain a copy of the “Master handbook of acoustics” for an even broader perspective on the subject.

You need more power. The Counterpoint SA-100 is 100 wpc @ 8 ohms and is not quite enough. Try the SA-20 or SA-220. That should fix most of your problem. You could also change jumpers, if possible. A powered sub w/active x-over is another option, too.

Regards
Jim

What version of the SMG do you have ? I can help but need to know before I can give you an answer. I have owned over a dozen Maggies of various types.

I don't know the speaker in question, but more power is always better with Maggies.

If you have not been to audioasylum.com try it. Click on Planar/statics/Ribbons speakers. Ask the question there. You'll get the best info from Mart and other inmates regarding crossover modes.

Good luck