Need help with phono cartridge selection


I have 2 Dynavector phono cartridges. Ultimo 20C and Ultimo 10A. I know that the 20C is a low output MC and that the 10A is a high output cartridge. I have sampled half speed mastered vinyl with both mounted on a Denon DP 30L II turntable and have experienced pluses and minuses with each cartridge. I am using a Hafler DH500 amplifier with a PS Audio 5.6 Preamplifier for electronics and Snell Type A loudspeakers. Simple question...with this setup... which cartridge should I keep ? Ultimately my ears must be the judge and I understand that, just looking for opinions.
rettuc01

Showing 2 responses by rettuc01

They are late 80's models...but I purchased them recently new in the box. I examined the stylus, cantilever and housing and they are spotless.

There is some blog info out there about the 10A...but precious little on the 20C. The 10A retailed for about $ 390.00 and the 20C was around $ 550.00. They both have very dynamic sound reproduction qualities and I have the orginal spec sheets and independent test metrics. I am just not that knowledgeable about high versus low outputs and their interactions with the equipment I own. The Preamplfier has a MM/MC switch in the rear that is tied to a phono stage in the chassis so I am able to utilize the MC cartridge...but I don't have the paperwork any longer for the Pre so I can compare specs for it against the cartridge.
Good answer. :)

They both exhibit wonderful sound reproduction.

My post was mainly for obtaining information from folks that have had system experience with the aforementioned products, so I can benefit from that knowledge and properly evaluate the cartridges.