My First DIY Power Cable


Thinking of trying my first DIY power cable.  Would like to keep it under couple hundred $$.  Looks like it could be done with products from the Furutech site.  Any other resource recommendations?

128x128jbuhl

Showing 6 responses by mbolek

@jbuhl  Don't stress.  Focus on good conductors, good connectors and secure connections...

Lots of knowledge from Steve and the other folks.   I have used both Viborg and SonarQuest.   Both are very good.  Even though I prefer silver over pure copper, I have no issues using rhodium based connectors.  

Nice Easter sale going on at partsconnexion, so may be a good time to pick up more DIY stuff...

If you like the Viborg story, go with their bulk power cable.  I have a couple and they are solid.

 

 

 

 

@mitch2 

 

Never said the cable was 19awg.  L/N are ~12awg, G ~13.5.  Pretty adequate for a PC.

 

Hi Steve,

 

As you posted...

Red - line 

Black - neutral

Yellow - ground

Although, each wire/conductor is 19.5 AWG.  

This is very solid cable.  Prices have actually dipped below $100 at times...

 

https://smile.amazon.com/Viborg-Audiophile-MTR-VP1501-Multplex-Connector/dp/B07RB15YPH?ref_=ast_sto_dp&th=1

Steve,

May have to try swapping the the yellow/red as you point out. I have two cables so could be an interesting eval...

Plus they are terminated with fork terminals for easy/secure connections.

 

Marty