montana eps crossover ???

What do you intend to do with the circuit diagram if you got it ? All the drivers are propritary i.e. built especially for us and not available "off the shelf" so building copies are out of the question.

Hi Jb0194 and Chadnliz,

I sincerely doubt that Mr. Short from North Creek (funny coincidence, my last name directly translated from Danish, my country of birth - means exactly - "north creek") can install any better cross-over components than the EPS utilizes, both capacitors in the tweeter section are of the film and foil type, especially made for us - aluminium foil/ polypropylene film. The series cap in the bandpass for the mids are a combiantion of a film and foil bypass (10% of the value) and a metalized polypropylene film cap. All inductors are of the perfect layer type, large gauge where appropiate. In many cases a series resistance in an inductor is actually required and an integral part of the design

Yes -I aggee that diffrent components in cross overs may sound diffrent but that is just so, diffrent, not better.

I closing let me plaese point out that designing a Loudspeaker takes a long time, going through a lot of drivers, boxes, components and working with your suppliers to get exactly what you want and therefore at a considerable expense, the final topology of a cross-over I consider to be very propritary in nature and would therefore never release.

Thanks

Peter