2. misc-audio
  3. 163047-122106

Monos and mains,.. too close?

Hey folks,

I have just placed Ampzilla 2000 Second Edition monoblocks down low on the floor  on 6'' high platforms about 6'' behind the speaker plane of a pair of B&W Matrix 801 S2s.  

The toe in puts the front of each monoblock 8'' from the side of each speaker (the rear is about 13'' away).  

Are the monoblocks too close to each speaker?
Would there be any ill effects from the driver magnet being this close to the amp?

A few months ago I noticed my Hegel H190 starting to hum after I (temporarily) put a KEF LS50 speaker on the shelf next to it just a few inches away.  Called Hegel support, was asked to move the LS50 off the shelf, shut down, wait a few minutes, then power back up the amp.
Problem solved.

Now I have 12'' drivers in the B&Ws (vs 5'' in the LS50s) just a little bit farther away from each amp.

If too close, would elevating the speakers on 12'' stands create enough distance?

I am trying to keep speaker cables as short as possible while running long balanced ICs from my preamp.
Also trying to keep the amps away from either side of a steam radiator that sits between them.


Stay safe and happy listening everyone!  











hleeid

Showing 3 responses by hleeid

hleeid OP
219 posts
 
Yeah, that radiator does get noisy.  A wooden handle tap does create some ringing. 
I just placed a few folded moving blankets over the radiator.  There was a noticeable ringing in the midrange that is almost gone now.
Thanks again oldhvymec!

Will get around to using lower platforms for the amps and keep them as far back as possible.


hleeid OP
219 posts
 
Didn't occur to me to rotate the amps.  Right now, they are set up with the fronts facing the listening position and parallel with each other.

Rotating them 190 degrees (speaker posts facing listening position) would actually allow for shorter speaker cables as the speakers are going on stands and will be pulled a few feet farther away from the wall behind.
This will place the rear of each amp close to the same plane as the rear of each speaker.




hleeid OP
219 posts
 
Regarding sound quality, I understand the reasoning behind minimizing the amount of components (amps, preamps, sources, TV, etc.) between the speakers.

However, if the only option for placing amps is between the speakers, is it best for the amps to be as low as possible?
Should they be placed as far behind the speakers as possible?
More to discover