Mogami balanced cables .... or another brand?

For Mogami, Canare: Markertek.com

Check out http://www.haveinc.com and a step up (without breaking the bank) is http://www.bettercable.com. I have purchased from both and have been very pleased with them.

L

Signal Cable are very affordable as well.

I think Ralph Karsten of Atmasphere amps fame uses Mogami balanced cables with his gear because his fully differential/balanced designs mostly negate the influence of cables on the overall sound.

That's a pretty damn good vote of confidence for the quality of their balanced cables considering he's obsessed with neutrality.

For Mogami 2534 Quad Mic cable try:
http://www.redco.com or
http://www.thecablefactory.net/audio-cables-199/microphone-cables-28/mogami-xlr-microphone-cable-728.html

A 50ft XLR terminated cable is around $65-$75.

I had Redco make a 30ft pair to try between my Atma-Sphere preamp and amps. Build quality was fine and deliver time was pretty quick.

I contacted Redco and their prices are outstanding.

The Gotham GAC-4/1 (the counterpart to Mogami 2534) has been highly recommended as well.

Thanks to everyone who responded.

05-13-08: Tvad
If Atma-Sphere's balanced designs negate the effect of balanced interconnect cables, then Ralph's use of Mogami wire says more about his endorsement of using inexpensive balanced ICs than it does about the quality of Mogami wire.

I think you have jumped from a qualified statement to a sweeping generalization without cause.

I have not seen Ralph write that all low-cost balanced IC's work well, but I think I have seen him write that Mogami's do.

And I have seen him write that well designed and executed differential/balanced systems minimize most cable influence. But, I don't think I have ever seen him write that D/B systems negate "all" cable influences from all balanced cables. That is why I attempted qualified my statement with "mostly" because an extremely low-quality, poorly designed and constructed, balanced cable might still have a profound negative effect.

Mogami are nice quality. I use Mogami and Yorkville and Mogami are better built but roughly twice the price.

I switched PAD Dominus Rev C cable (at quite a few $ K) to Mogami 2534 between my MP-1 and MA-2, saved more than $3K and have indistinguishable sound. I repeat and stand by that statement!

Good points Tvad, it just that I don't have any first hand experience with Atma gear or RK's thoughts outside what he's posted on audio forums. So, I was unqualified to say anything more.

I've followed your component swapping journey and know you put parts through their paces, so I happily defer to your greater hands-on experience.

Thinking of Mogami's? I'll add a vote. I ordered a full set because I really needed them - I had some "older and mixed" IC's - and definately questionable in terms of integrity.

I chose Mogami because many recording studios consider them a industry standard. No Hype.

I included balanced XLR's from a Proceed AVP2 +6 (processor) directly to powered front monitors. Very sweet, balanced sounds and the price to upgrade my entire sytems' IC's was great.