2. cables
  3. 1253472256

MIT Burn In ?

I have burned in 2 sets of MIT Shotgun S3's IC's.It was a long drawn out process as I left cdp,preamp and amp on.I Just purchased a single Shotgun S3 Ic for center channel to amp.I was just reading on the MIT website that states"If burning in interconnects only, your amplifier does not have to be turned on—just source components."Does this mean I can connect the single IC to my cdp and play continuously with the preamp and amp off.I have read all the burn in threads but am still confused.And if that is the case can I use 2 cd players and hook a set of IC's to both and then hook one set to cdp on preamp and one set to tape on preamp and play both cdp's and leave the preamp and amp off and IC's will still burn in.Thanks
shaunp

Showing 1 response by buff

buff's avatar
buff
210 posts
 
Hi Shaun,
As long as the interconnect are getting signal through them it will burn them in.
MIT break in is over 300 hours.
You can hook up two different CDPs to one preamp using different inputs on the pre and play both cd players on repeat to burn in your cables.
hope that helps
More to discover