McIntosh A-116 A116 Biasing and tube swap

Hello all:

Just had a quick question. I've recently obtained the McIntosh A-116 Monoblocks and one of the 12BH7 tubes was DOA. I've read that I could swap it out for the 12AU7. Is that true? Also Can anyone share with me how to set the bias on the amp and if anything needs to be done so that I can use the 0.5 input terminal? Thanks in advance!

Showing 2 responses by aball

The 12BH7 has split duty, one side at 50V and the other at 240V. The latter voltage is a bit high for a 12AU7 but it will work since the cathode current is only 7.5mA. But I see no reason to do that when you can get 12BH7s just as easily and for equal cost.

No biasing needed - and it will probably sound better on the high-gain inputs. Just be sure to dial back the gain controls before turning it on that way.

If you decide you don't want these amps, let me know. :)

Yes, Terry is the man. But in the NYC area, you have who would be able to do all the work, no problem. They are in Vestal, near Ithaca - hopefully that is a doable drive for you because they are McIntosh experts.

Believe it or not, the new production Electro-Harmonix 12BH7s are quite good. Not quite the level of the NOS Tung-Sol black plates I am using now, but 90% of the way there for little cost and basically no risk.