Hi Mark -
Thanks for your interest in my work. One correction: the $500 upgrade you describe is the Revision A - not the "B." You are absolutely correct that the Rev A is a complete rebuild, including circuit topology improvements as well as a full set of the best resistors, capacitors, wire, and jacks. The result is a very serious phono stage, and the people that have had this work done have expressed a lot of enthusiasm about the finished product. It's an across-the-board improvement.
The new power supply (the Micro Power Station) is optional, but recommended. In truth it is a relatively small upgrade over the original wall-wart, but it *is* an improvement and it does allow you to use a good after-market AC cord.
Regarding your e-mail question about the gain, I am a little surprised that you aren't hearing any clipping when running your high-output Glider with the High gain setting. There is no danger of hurting anything so it's no big deal, but watch out for phono stage clipping on highly modulated records.
That's all I have for the moment... I am currently out of town but will be back in my office on Monday the 27th if you wish to call.
All my best to you and other 'Goners,
Steve McCormack
www.SMcAudio.com
Thanks for your interest in my work. One correction: the $500 upgrade you describe is the Revision A - not the "B." You are absolutely correct that the Rev A is a complete rebuild, including circuit topology improvements as well as a full set of the best resistors, capacitors, wire, and jacks. The result is a very serious phono stage, and the people that have had this work done have expressed a lot of enthusiasm about the finished product. It's an across-the-board improvement.
The new power supply (the Micro Power Station) is optional, but recommended. In truth it is a relatively small upgrade over the original wall-wart, but it *is* an improvement and it does allow you to use a good after-market AC cord.
Regarding your e-mail question about the gain, I am a little surprised that you aren't hearing any clipping when running your high-output Glider with the High gain setting. There is no danger of hurting anything so it's no big deal, but watch out for phono stage clipping on highly modulated records.
That's all I have for the moment... I am currently out of town but will be back in my office on Monday the 27th if you wish to call.
All my best to you and other 'Goners,
Steve McCormack
www.SMcAudio.com