2. analog
  3. 1342299623

Lyra Kleos: tracking force/VTA/azimuth questions

I just bought a Lyra Kleos and I'm mounting it on a VPI JMW 12.7 (HRX turntable). I've done a bit of research, including Jonathan Carr's many posts here), so I know VTF is critical. I've done a trial set up to Lyra specs, and it doesn't sound right - piano in particular is distorted as if the cartridge is approaching break-up. I suspect the way I've set VTF. VPI recommends measuring VTF at the level of the record, which is impossible with the electronic scale I currently use - I simply put it on the platter and took readings, after first calibrating the scale, of course, and left it at 1.75 g. VPI says that simply measuring tracking force that way will under-represent actual VTF at the level of the record by a substantial amount because of the height of the gauge over the platter. Could that be the source of the problem I'm hearing? With other carts, I've done a couple of tests that seem to verify VPI's advice, so I plan to carefully measure the plinth to platter-top height, remove the platter, and build a temporary platform lower by exactly the thickness of the scale's pan. I'll put the scale on that, and then set VTF to Lyra's specs. This will result in VTF at the level of the record measuring correctly, when I put the scale on the mock-up platter, but NOT when I just slap the scale on the platter - it will measure higher. So my question is: does anyone see any potential problems flowing from my use of this process? I plan first to set VTA slightly tail high to approximate the magic 92 degrees SRA that seems to be the consensus of opinion these days.

Also, I'd like a bit of advice on using a fozgometer to measure azimuth. In my trial set up, I've never been able to get exactly the same readings left vs. right channel with the Foz; the best is a two-division difference, right higher in level than the left. I also get a one division reading, rather than zero, on the channel balance test, with both channel lights very faintly lit. Could this be a function of insufficient tracking force, or is there something else at play?

Thanks to any and all who might feel the spirit to respond (hopefully including you, Mr. Carr).
zachteich

Showing 1 response by syntax

syntax's avatar
syntax
2,193 posts
 
I am getting wonderful sound as it is out of the Kleos. I
actually like this cartridge better than the original Titan I used to have.

Yes, the Kleos is a wonderful cartridge for average analog Systems which are
pretty simple in all components. Makes life pretty easy, it does not change
performance very much, no matter in what position it is mounted.It is a very
good cartridge for the majority of the current reissues which have a lot of
groove noise, tics, pops, based on its very limited high frequency ability.
Listening to such reissues with the Titan i is simply a pain, you hear all the
faults in the pressing process and incompetence from the Mastering guys...but
the better that one is, the Titan i will follow, it has no limit. In a way, a very
remarkable cartridge, but also a very demanding one. I bought Titan i twice.
More to discover