This question was asked in a post a few years back.
This was my solution at the time. Still is...
I've had quite a few new LPs with spindle holes that were a very tight fit and would bind on my VPI HW-17 RCM. The $12 answer was in my shop, a T handle reamer. You can pick one up on Amazon, see the link below. In almost ever case I think it was not a matter of the hole itself being too small, but just some residual flashing. This tool will take it out in no time. A word of caution.....apply virtually no pressure when reaming as the tool will cut vinyl like it's not even there and you'll end up with an oversized spindle hole. A very light touch is all you'll need, just let the weight of the tool do the work. Great tool with plenty of other uses.
http://www.amazon.com/General-Tools-Instruments-130-Handle/dp/B00004T82J/ref=sr_1_5?ie=UTF8&qid=1449962462&sr=8-5&keywords=reamer
Jerry
This was my solution at the time. Still is...
I've had quite a few new LPs with spindle holes that were a very tight fit and would bind on my VPI HW-17 RCM. The $12 answer was in my shop, a T handle reamer. You can pick one up on Amazon, see the link below. In almost ever case I think it was not a matter of the hole itself being too small, but just some residual flashing. This tool will take it out in no time. A word of caution.....apply virtually no pressure when reaming as the tool will cut vinyl like it's not even there and you'll end up with an oversized spindle hole. A very light touch is all you'll need, just let the weight of the tool do the work. Great tool with plenty of other uses.
http://www.amazon.com/General-Tools-Instruments-130-Handle/dp/B00004T82J/ref=sr_1_5?ie=UTF8&qid=1449962462&sr=8-5&keywords=reamer
Jerry