2. amps-preamps
  3. 180029-149900

Low buzzing through speaks

Hello All,

 

Need some serious help here. So I just (upgraded?) from a Marantz AV8802A to a McIntosh MX122 preamp. I also just got brand new Revel Performa3 speaks all around (5 channel setup). I disconnect everything from the Marantz and then into the McIntosh, connect the speaks and I have a faint buzzing through all 5 speakers (that was not there previously). I have everything plugged into a Furman Elite 20pfi power conditioner which is plugged into a dedicated 20 amp circuit. My power amp is a Simaudio Titan HT200 5 channel. This is not going through the Furman but directly into the other outlet on the same 20 amp line. I even tried plugging the Sim amp into the Furman to see if that helped-no change faint buzz is still there. I have unplugged just about everything, and the buzz is still there. It is very faint and does not get louder when I turn up the volume. Again it is faint and you have to put your ear up to the speaks to hear but it is definitely there. I have tried so many things and nothing gets rid of it. It is not my cable box (I did have that issue previously with the Marantz but as soon as I unplugged the coax from the box it went away so I just bought a coax loop eliminator connected the cable to that and noise was all gone) as I unplugged that and started there.

 

Any help would be so sincerely appreciated????

kingbr

Showing 2 responses by jackd

jackd
1,037 posts
 

If you've got IC's and PC's crossing over each other that's your problem.  Clean up the cable nest and the problem should go away.

jackd
1,037 posts
 

@kingbr 

 

Your thought process of wanting to get the processor to the top is a good one in theory though as it will have to most cables coming in and out it increases the chance for power and signal cables crossing.  Though a royal pain in the ass the only way to likely to get the problem under control will be to remove all of the cables and start over again grouping the two types into two groupings and using something to keep them somewhat bundled so they don't stray.  I just it myself in two racks and it was a process. 

More to discover