2. digital
  3. 1439450586

Looking for new DAC: one box or two?

Hello all. I am considering a new DAC to replace my Musical Fidelity TriVista 21, which is fed by a MF A3.2 CDP. For digital, I currently listen only to redbook cd, no SACD or computer audio (yet). I like the sound I have but know that the TriVista is probably quite outdated compared to today's DACs. My question is: should I look for a one box CDP/DAC or a stand-alone DAC that I can feed with my A3.2 CDP (which--knock wood--has been trouble-free for 12-13 hrs.)? Vinyl is my primary source, but I have a lot of cds and still enjoy listening to them. Thanks for your advice.

System: VPI Scoutmaster TT (SDS, upgraded clamp), Soundsmith Paua cartridge, Transparent Reference Phono MM2 cables, Herron VTPH-2 phono stage, Musical Fidelity TriVista 21 DAC, Musical Fidelity 3.2 CDP, Transparent digital cable and music link Ultra interconnects, Musical Fidelity NuVista 800 integrated amp, Transparent Reference MM2 speaker cables, and Wilson Audio Sashas. Also Transparent power conditioner and power cables.
arsh

Showing 6 responses by coli

coli
291 posts
 
Actually, older DAC tends to sound significantly better than modern DAC, especially if it's R2R and limited upsampling (or better yet NOS).
coli
291 posts
 
Yes, do A?B comparison. There are some really high priced snake oil DAC out there so be careful.
coli
291 posts
 
Snake oil DAC: PS Audio Directstream
coli
291 posts
 
Actually, there's plenty of high end DACs that sounds no better than cheap AV Receivers.
coli
291 posts
 
Seriously, try Onkyo reciever/processors, they sound better than most $2000 DACs.

High priced DAC are scams unless you go for those custom R2R NOS Dacs.

Although NOS is coming back in the main stream again, Marantz AV8802 uses "super slow roll off", which is very close to NOS or is basically NOS.
coli
291 posts
 
Here's another tip, look up the chip the DAC uses, if it cost under $10, you should pay at most $500 for it. Eg: Burr-Brown, Sabre, AKM. You can get the same sound out of consumer AV receiver/processors (if you want XLR) for far cheaper, plus you can go multichannel processing.

Onkyo and Marantz are just so far ahead of DACs in terms of sound quality and bang for the bucks.

Also, avoid all FPGA DACs, those simply sound incorrect. Maybe they'll fix it in 10 years with firmware upgrades, but you'll be able to buy them dirt cheap by then.

If you want things to sound better, invest in balanced power and a reclocker. Once you got those 2, every DAC based off of $1-$10 chips sounds the same.
More to discover