Looking for a Little Help...


Hey!Guys,
I need some input & advise, on a decent pair of audio connects. I own (Two)Carver A-500-X Amps, that I want to make into a mono-block set-up & become stereo. It's to run my two-channel analog/ vinyl L.P.'s. I'm familiar with most name brands: Cardas, Z-systems,Audio Quest, etc..

This wire needs to be able to pass "800" watts into 8 ohms.10 Guage wire is about as thick as I can handle through the binding post.

I'm powering an Oracle Delphi Mark V Turntable,a Carver CT26-V Tuner/Preamp & (2)Polk Audio Moniter 10's.

I could use a few price ranges. I know how this stuff can be pricey...

Thanks,
Mike
the_chops

Showing 1 response by newbee

FWIW, in addition to the suggestions above,I would suggest that you explore some very good quality and inexpensive speaker cable and then you have, at least, estblished a benchmark for auditioning better/more expensive stuff later on.

Lacking knowledge about your amp or speakers and any special needs you might have, cable wise, I would suggest something that many users on this forum have tried and liked, Canary Star Quad (I think I've got that right). I think its constructed out of 4 14 guage twisted copper wires with a total guage of 12. You probably won't dislike this cable in your system and in fact you might like it well enuf to stop searching for some time to come. I've use it in a 2d system and am quite pleased with the price/performance ratio.