Logitech Duet sonds awful


I recently installed a Logitech Duet in my stereo and it sounds digital and gritty. I'm saving my cd files to WAV with Apple's Itunes and listening through the Logitech receiver with both digital outs to a Entech DAC which sounds better with my Ipod with the best resolution MP3s (highest resolution) and I'm wondering if I was naive in thinking that the digital wireless transmission wouldn't affect the sound.
shlibotnik

Showing 3 responses by mapman

It's not the digital wireless transmission most likely unless perhaps you have a bandwidth limit set on squeezeserver (not the defaultqhich does not set a limit). This might be done to avoid rebuffers that might occur if your wireless network were a bottleneck. That would only likely occur though if you had multiple squeeze devices streaming concurrently or others were using wireless bandwidth for other tasks concurrently, and/or if there is a weak signal between either server or sb and router.

Realize that the job of any network with a music server is merely to transfer bits fast enough to keep up with real time play of music. Data transmission itself across any network, wireless or otherwise, has absolutely nothing inherent to do with sound quality, which is 100% determined by the combined process from the player (sb) to dac to amp to speakers. So the problem is most likely there somewhere, assuming aso that you are getting accurate rips to disk. What CD ripping software are you using? Make sure also that nothing unexpected is happening there. Some ripping software is designed to enable faster rips by reducing rip quality using error correction techniques that might adversely affect sound quality.
"I have found with my SB Touch that using it hard-wired, via ethernet, does sound better than using it wireless. Sorry, I have no explanation for that, it's just what my ears are telling me."

If so, I am at a loss for an explanation.

I do know as I mentioned that squeezeserver can be configured to operate at a bandwidth limit if explicitly configured that way. But not by default I am pretty sure. I would check to see if this is the case. Even if so, I do not think the server is designed to apply any lower resolution transmission rates automatically based on connection type. Of course, anything is possible when computers and programming is involved. Could be an undocumented "feature" to avoid annoying rebuffering. I don't think this is the case but not beyond the realm of possibility.

I will stick to my assertion though that a wireless connection alone does not mean lower quality sound. Teh devices and software using the connection would have to be the culprit.

I don't doubt you hear what you hear. Sounds better in what way? Are you doing immediate a/b tests when you hear this?

I suspect it is due to some other difference associated with each configuration, though not certain what that might be. Is the physical location of the SBT the same in both cases? I would tend to go with a wired connection if so in general for bandwidth reasons, but I would not expect a difference in sound.
"Hard wire it with Ethernet, yes there is a difference. Research the subject on squeeze forums."

Can you summarize what the difference is and its cause as indicated on the forums?