Likely culprit for harshness at higher volumes?


Hi,

I'm a newbie to higher end audio. I have a very modest system:
1) Pre-amp: Anthem AVM2
2) Amp: Adcom GFA-5400
3) Source: Sony CDP-X111ES CD player
4) Speakers: KEF C75
5) Toslink between source and pre-amp; cheap RCA cables from pre-amp to amp; 16 or 18 gauge speaker wire (Radio Shack?)

Room setup (10-ish feet x 20-ish feet rectangle):
1) 2 foot deep cabinets along one wall (20-ish foot)
2) Components stacked on top of small end table against rear wall (10 foot); centered between cabinets and opposite wall.
3) Speakers slightly in front of end table and about 2 feet from side walls and 4 feet from rear wall

Sounds good at about -45 to -25db; but higher frequencies get harsh at higher than -25db.

Appreciate your thoughts.
saru

Showing 1 response by magfan

perhaps clipping.
Source music is awful, as has been noted by Shad, above.......look up 'loudness wars' if your want more info.

Also, Since speakers so not have watts, I'd simply ignore that rating. Good, loud, dynamic music demands a lot of an amp. Maybe it's just not passing muster.