2. digital
  3. 1090068720

JoLida 100 potential problem


Hi there,

Yesterday I recieved my Rca tubes and I immdiately installed them. Easy enough to do enough though it's pretty cramped inside maybe it's due to my level-2 mod. On to my question when I installed the new tubes and put back the metal sheaths I tried to tighten the screws but was unable to do so. I left them unscrewed in this state can a problem what so ever occur. I'm mostly concerned when moving the player that the screws will pop out.

Thanks

freakygreek

Showing 2 responses by ketchup

ketchup
688 posts
 
It's pretty tricky to re-tighten those screws because, as pauly said, there are nuts on the back side of the circuit board. When I tightened mine, I loosened the board and pulled it up just enough to get a wrench under the cicuit board. It's tough because the wires going to the output jacks are very short, but it can be done without completely removing the circuit board.
ketchup
688 posts
 
You can do it :)

Disconnect the connectors on the circuit board, remove the screws, and lift it up enough to gain access to the nuts on the bottom of the board. A small wrench set will help hold the nuts when you tighten the screws.
More to discover