It costs me $100 a week to listen to vinyl


I know the math is obvious, but with the price of high-end moving coil cartridges averaging $5000.00 and with me averaging 20 hours a week of vinyl listening, I was disturbed to calculate that I am paying $100.00 per week for the privilege of listening to my own records?
I realise that doesn't include the depreciation on my equipment or electricity costs etc so please don't remind me of this?
How smug those who can bare digital must feel about this?
And how much worse for those committed to valve replacements in their pre and power amps?
How can we expect younger audiophiles with mortgages to pay, families to raise and education to provide for to afford the price of entry into an analogue system with such a potential maintenance impost?
I realise there are cheaper cartridges out there and the MMs are a bargain compared to the MCs, but once 'hooked' on vinyl, the desire to 'upgrade' is encouraged by the reviewers and the audio magazines continually announcing a newly anointed 'Kingpin' cartridge which is inevitably a moving coil with a price approaching the GDP of Namibia.
There seems to be no critical challenges to the assumed supremacy of MCs over MMs except for the lone crusade of Raul on this Forum?
Well I have taken the 'Raul challenge' and switched to a 15 year old MM cartridge which cost me $300. The 'running costs' of this are obviously a 'snip' compared to my $5000 MC but the best thing is the revelation that this moving magnet cartridge (and probably many more), are not only as good as some of the vaunted MCs in the market place, but better than most and sometimes by a considerable margin.
As Raul continues to implore us.........."try it, you may be surprised?"
128x128halcro

Showing 2 responses by paulfolbrecht

Quit listening to the reviewers. I think anyone who truly has an ear for acoustic music realizes that a < $2K vinyl setup with a <$500 (or even <$200) cart beats any digital there is, and can be entirely musically satisfied.

Get a 103 or 103R (with a suitable arm!) if you don't want a high "hourly rate" with your vinyl.

(My other hobby, or rather at this point perhaps I should say my other former hobby, was flying, where $100/hr for the experience is reasonable. For listening to music - hardly!)
Raul,

I respect your op on MM carts. I have had a couple that I liked. But could you recommend something specific to try that would perform well on a heavier arm like an SME 3012?