use it under your transport. You will love it and will expend less than $15.00 for a set of 3 units.
http://www.audiocircle.com/circles/galleryimage.php/albuo21/DSCF0021.jpg
Parts:
3 concave door knobs from Home Depot
3 1/2" steel bearings
3 copper end cups ( end caps) from Home Depot
sand
Crazy Glue
Fill each cup with sand
Dip the concave knob into the cups and make pressure
Turn upside-down the cups and add Crazy Glue to the edges
Let them set for about 5 minutes
Place the final product under the transport using a triangle configuration and with them distributed under the moving/vibrating parts first. That is, under the transformres and disc tray area before and use the other one to balance the whole system.
Add some weight over the top of the transport and do some trials.
The picture is on the www.audiocircle.com forum. You will see the cups under the white T device which is a T-Bone Roller , but you don't need this, just the cups with the bearings on top of the cups.
You can e-mail me if you need asistance.
Good luck,
Jahaira.
http://www.audiocircle.com/circles/galleryimage.php/albuo21/DSCF0021.jpg
Parts:
3 concave door knobs from Home Depot
3 1/2" steel bearings
3 copper end cups ( end caps) from Home Depot
sand
Crazy Glue
Fill each cup with sand
Dip the concave knob into the cups and make pressure
Turn upside-down the cups and add Crazy Glue to the edges
Let them set for about 5 minutes
Place the final product under the transport using a triangle configuration and with them distributed under the moving/vibrating parts first. That is, under the transformres and disc tray area before and use the other one to balance the whole system.
Add some weight over the top of the transport and do some trials.
The picture is on the www.audiocircle.com forum. You will see the cups under the white T device which is a T-Bone Roller , but you don't need this, just the cups with the bearings on top of the cups.
You can e-mail me if you need asistance.
Good luck,
Jahaira.