Hi,
Want an inexpensive record cleaner? This is what I use. A 5 gal wet/dry vac. Take the head, with the rubber squeegie inside, and remove the rubber insert. Take a piece of foam, or sponge, large enough, to cover it, and come up the side, a little. Tape it with duct tape, so that the tape, does not get, into the area, that comes into contact, with the surface intended to be vacuumed. In other words, tape only the sides, of the head, to tape the foam, in place. Take a razor, or box cutter, and make a five inch slit, in the area of the foam, that is now in the area, that the rubber insert was.
I use a mixture of 1/4 Joy dishwashing liquid, to 3/4 distilled water, in a spray bottle. Do not spray, the label area. Use a stiff bristle brush, and scrub the record. A brush, is far less pressure, than a diamond, at 1 gram, running along the grooves. Use a folded towel, and wipe most of the liquid off. Use the vac, and vac the surface. It has enough suction, to pull the remaining water, right through the foam, and the slit, allows it to suck the record dry. I sold my cleaner, after using this contraption. It took me about 15 minutes, to cut the foam, and tape it to the head. It works.
I use a tv turntable, to turn the record, while I vac it. The record sits, on a old Kenwood platter, which sits on the tv turntable.
And best of all, if I spill something, I just remove the head, and presto, I have a wet/dry vac, again.
Want an inexpensive record cleaner? This is what I use. A 5 gal wet/dry vac. Take the head, with the rubber squeegie inside, and remove the rubber insert. Take a piece of foam, or sponge, large enough, to cover it, and come up the side, a little. Tape it with duct tape, so that the tape, does not get, into the area, that comes into contact, with the surface intended to be vacuumed. In other words, tape only the sides, of the head, to tape the foam, in place. Take a razor, or box cutter, and make a five inch slit, in the area of the foam, that is now in the area, that the rubber insert was.
I use a mixture of 1/4 Joy dishwashing liquid, to 3/4 distilled water, in a spray bottle. Do not spray, the label area. Use a stiff bristle brush, and scrub the record. A brush, is far less pressure, than a diamond, at 1 gram, running along the grooves. Use a folded towel, and wipe most of the liquid off. Use the vac, and vac the surface. It has enough suction, to pull the remaining water, right through the foam, and the slit, allows it to suck the record dry. I sold my cleaner, after using this contraption. It took me about 15 minutes, to cut the foam, and tape it to the head. It works.
I use a tv turntable, to turn the record, while I vac it. The record sits, on a old Kenwood platter, which sits on the tv turntable.
And best of all, if I spill something, I just remove the head, and presto, I have a wet/dry vac, again.