Merry Christmas everybody. I got a question about the 45/2a3 type amps in regards to driver size. Even if you have a speaker that is very high in efficiency but has say 12” or 15” drivers, does a low watt amp still work its magic or would it struggle?
If you love SET amplifiers, boy do I have speaker for you.
I have had in-house for the last six weeks a pair of speakers that I'm reviewing for hometheaterreview.com from NSMT Loudspeakers, located in North Carolina, that are a perfect match with SET amplifiers. I love SET amps. However, historically I'm not a fan of single driver designs (rolled off high-end/lack of bass) or horn designs (I find them to have coloration that annoys me after a short while) that are normally used with beautiful sounding SET "Flea Watt" amps. I have reviewed both types of speakers and they were good, but not keepers for me because of the above stated reasons.
The NSMT Model 50 is a small very attractive floor-stander which has an sensitivity rating of 101 dB and never dips below 8 ohms. It is a three driver MTM two way design that loads into a double transmission line and really reaches down to 35Hz to 20 kHz in my room. This is the third speaker I have reviewed from NSMT, the other two were wonderful music makers, and shows what a talented designer that Erol Ricketts is in all his designs at applying his unique version of transmission line loading.
Now, the Model 50 sounds terrific with high power SS or tube based amplification. But what has been enchanting for me is when I drive it with either a SET 2A3 amplifier, around 3.5 watts, or my Linear Tube Audio MicroZOTL as an integrated using the NOS 1940's Tung-Sol 6SN7 black glass oval plate tubes which produce only around 1 Watt. With either amplifier this speaker completely disappears, the beautiful colors/timbres just float out and 3D chunky images of the players fill the soundstage. However, because of the very high sensitivity of the Model 50 and its transmission line loading the foundation of the music, true deep bass, and overall dynamics/dB levels are hard to believe.
So, if you have or always wanted to try out a SET amplifier this speaker is a great choice. The Model 50 retails for $1,800.00 a pair, so they are very affordable to team-up with your SET amplifier. If you want a lot more details just go to NSMT-loudspeakers website.
The NSMT Model 50 is a small very attractive floor-stander which has an sensitivity rating of 101 dB and never dips below 8 ohms. It is a three driver MTM two way design that loads into a double transmission line and really reaches down to 35Hz to 20 kHz in my room. This is the third speaker I have reviewed from NSMT, the other two were wonderful music makers, and shows what a talented designer that Erol Ricketts is in all his designs at applying his unique version of transmission line loading.
Now, the Model 50 sounds terrific with high power SS or tube based amplification. But what has been enchanting for me is when I drive it with either a SET 2A3 amplifier, around 3.5 watts, or my Linear Tube Audio MicroZOTL as an integrated using the NOS 1940's Tung-Sol 6SN7 black glass oval plate tubes which produce only around 1 Watt. With either amplifier this speaker completely disappears, the beautiful colors/timbres just float out and 3D chunky images of the players fill the soundstage. However, because of the very high sensitivity of the Model 50 and its transmission line loading the foundation of the music, true deep bass, and overall dynamics/dB levels are hard to believe.
So, if you have or always wanted to try out a SET amplifier this speaker is a great choice. The Model 50 retails for $1,800.00 a pair, so they are very affordable to team-up with your SET amplifier. If you want a lot more details just go to NSMT-loudspeakers website.