2. amps-preamps
  3. 1103538881

How to equalize a bi-amplification setup?

Greetings!

Any one experienced in bi-amplification setups with different amplifiers, where output must be equalized?

In my bi-amp setup I use one pre-amplifier connected two different amplifiers, via balanced and unbalanced connection, feeding a pair of 2-ways loudspeakers (Pass Aleph P, Pass Aleph 3 on tweeter and Pass Aleph 0s on woofer).

Problem is the Aleph 0s results in a final higher sound volume (at least +3dB). Theorically I think this should not happen as manual gain of both amplifiers indicate a +20dB gain, altough the Aleph 0s outputs much more current.

How can I "calm down" the bass amp without comprimising the sound quality and without opening the loudspeaker to introduce one attenuation circuit?
sony

Showing 2 responses by sogood51

sogood51
2,157 posts
 
I don't remember your gear...it's been a while. Can you switch inputs on the amps so that the extra gain from using balanced is on the upper freq's and not the bass. 3db is not a lot and may be able to be smoothed out a little from speaker placement with a pick-up of 1-2db in the bass freq's through room gain.

I usually don't post on gear I'm no longer up on but did use this type of approach at one time in a past setup...sounded much more in step so if no use with your problem...may help someone else latter.

Dave

Dave
sogood51
2,157 posts
 
I don't remember your gear...it's been a while. Can you switch inputs on the amps so that the extra gain from using balanced is on the upper freq's and not the bass. 3db is not a lot and may be able to be smoothed out a little from speaker placement with a pick-up of 1-2db in the bass freq's through room gain.

I usually don't post on gear I'm no longer up on but did use this type of approach at one time in a past setup...sounded much more in step so if no use with your problem...may help someone else latter.

Dave
More to discover