I BI-Amp the lows with a different amp and use a behringer parametric Eq to adjust the input sensitivity and equalize two room resonances. I realize I am putting another device between the preamp and bass amp, however the ability to have relatively flat in room bass responce far outways the negatives. (At least for me)Pipe organ is a joy without that 40Hz room resonance I used to have and I don't have to mess with the mids and treble.
How to equalize a bi-amplification setup?
Greetings!
Any one experienced in bi-amplification setups with different amplifiers, where output must be equalized?
In my bi-amp setup I use one pre-amplifier connected two different amplifiers, via balanced and unbalanced connection, feeding a pair of 2-ways loudspeakers (Pass Aleph P, Pass Aleph 3 on tweeter and Pass Aleph 0s on woofer).
Problem is the Aleph 0s results in a final higher sound volume (at least +3dB). Theorically I think this should not happen as manual gain of both amplifiers indicate a +20dB gain, altough the Aleph 0s outputs much more current.
How can I "calm down" the bass amp without comprimising the sound quality and without opening the loudspeaker to introduce one attenuation circuit?
Any one experienced in bi-amplification setups with different amplifiers, where output must be equalized?
In my bi-amp setup I use one pre-amplifier connected two different amplifiers, via balanced and unbalanced connection, feeding a pair of 2-ways loudspeakers (Pass Aleph P, Pass Aleph 3 on tweeter and Pass Aleph 0s on woofer).
Problem is the Aleph 0s results in a final higher sound volume (at least +3dB). Theorically I think this should not happen as manual gain of both amplifiers indicate a +20dB gain, altough the Aleph 0s outputs much more current.
How can I "calm down" the bass amp without comprimising the sound quality and without opening the loudspeaker to introduce one attenuation circuit?