If you want to get superior interconnects for only one connection, I would recommend the CDP to preamp. This is because the CDP typically has the weakest drivers and benefits the most from a low-capacitance cable. Next in priority would be the pre to power connection.
How many quality interconnects to I need ?
I have a separate component system- amp,pre-amp, cd player, FM tuner, turntable.
My best set of interconnects are from RS Audio that are used to connect the CD player to the pre-amp (Parasound Halo P3).
I've read so many commentaries on interconnects, some which cost hundreds or even thousands of dollars. Does this mean every component must be connected with such expensive wire ? Or are the highest quality interconnects placed at the source with lesser quality wires elsewhere ?
I have not read a single review of any interconnect that specifies where it was placed in the test system . Any comments ? Thanks in advance....
My best set of interconnects are from RS Audio that are used to connect the CD player to the pre-amp (Parasound Halo P3).
I've read so many commentaries on interconnects, some which cost hundreds or even thousands of dollars. Does this mean every component must be connected with such expensive wire ? Or are the highest quality interconnects placed at the source with lesser quality wires elsewhere ?
I have not read a single review of any interconnect that specifies where it was placed in the test system . Any comments ? Thanks in advance....