You could set your pre at 47k and the solder a resistor in line on an rca, if your preamp doesn’t allow for resistor changes. In general I have found that a 400 ohm load played back at 100 ohms will roll off the highs and create a less than accurate picture of what your cartridge can do. It makes it sound boring and dull.
how does the Hana LOMC cartridge sound at 100 ohms?
Hana cartidges have got a lot of good reviews.The recommended impedance for the LOMC is > 400 ohms. Most phono preamps, including mine, are set at 100 ohms for moving coil. Does this mean the Hana will sound too bright if used at 100 ohms. Anyone tried it at 100 ohms???