The finest vibration control device I have found so far is the Vibraplane. The effects were immediate and obvious whereas most other products I have tried offer some to no effect. I also like Sistrum racks.
How do you deal with vibration?
Greetings all,
Many of us work very hard to keep vibration out of our equipment. I was hoping we could share our experiences with each other. I was wondering what other DIY methods people are using?
I personally have had good luck with shipping open cell foam under plywood. I find that about 60-70 percent compression works best. I place the foam underneath some plywood (Using spruce 3/4 inch). Then I place the component on the plywood. However, I think this more isolates the component from outside vibration. I don't think it does much to drain internal vibrations, especially in a CD transport.
Also I can not find open cell foam in town any more. I am ashamed to say that I actually went to Wal-mart to buy some. Now they don't carry it any more. So I was wondering where else I can get some?
I am currently thinking about building a Sandbox for my CD player and amp. Then putting the sand box on top of some sort of isolation material (open cell foam or cork rubber etc.) My thoughts are the foam or cork or etc should help keep the vibrations from getting into the equipment and the box should drain the internal vibrations.
Also, what are peoples experience with different woods. I live in BC so I can get most wood fairly cheap. I imagine every wood has it's own sonic signature due to it's resonant frequency. What works best? Solid maple, birch ply, MDF, walnut, mahogany etc...?\
Anyways, feel free to through ideas and experience (both good and bad) out there. It would be good to know what works and what doesn't.
Happy tweaking,
Nick
Many of us work very hard to keep vibration out of our equipment. I was hoping we could share our experiences with each other. I was wondering what other DIY methods people are using?
I personally have had good luck with shipping open cell foam under plywood. I find that about 60-70 percent compression works best. I place the foam underneath some plywood (Using spruce 3/4 inch). Then I place the component on the plywood. However, I think this more isolates the component from outside vibration. I don't think it does much to drain internal vibrations, especially in a CD transport.
Also I can not find open cell foam in town any more. I am ashamed to say that I actually went to Wal-mart to buy some. Now they don't carry it any more. So I was wondering where else I can get some?
I am currently thinking about building a Sandbox for my CD player and amp. Then putting the sand box on top of some sort of isolation material (open cell foam or cork rubber etc.) My thoughts are the foam or cork or etc should help keep the vibrations from getting into the equipment and the box should drain the internal vibrations.
Also, what are peoples experience with different woods. I live in BC so I can get most wood fairly cheap. I imagine every wood has it's own sonic signature due to it's resonant frequency. What works best? Solid maple, birch ply, MDF, walnut, mahogany etc...?\
Anyways, feel free to through ideas and experience (both good and bad) out there. It would be good to know what works and what doesn't.
Happy tweaking,
Nick