2. misc-audio
  3. 1141793234

Holy Crap What have I done?

Ya know that scene in "Aladdin" where Abu the monkey touches the huge ruby of the forbidden treasure and everything goes to hell around them? Well, *that's* kinda what happened to me tonight.

I finally found a Marchand XM9 crossover at the right price from an honest seller, and it arrived tonight. I put it in line between my preamp and amp, and it did both what I wanted it to do and what I didn't want it to do: it improved the "slam" of the bottom end, but sucked all the air out of the music and my system went from a pretty high degree of "you are there" factor to realizing you're listening to music on a good stereo.

Admittedly, I haven't played with the crossover controls yet, but I'll be quite surprised if they can "bring the life back" to my system.

Any thoughts on how to get my system to give me that "I'm in the room with the musicians" feeling again with the crossover still in line? Maybe I need to go to an XM44, or some other brand of crossover?

I should mention I tried the crossover because my nOrh mini 9.0's only go down to about 65Hz -3dB with a really quick downturn to -10dB (around 55Hz at -10dB, if I remember my measurements correctly.) I was happy with my ACI Titan crossoved over at 85Hz, but had read that using a crossover to cut the lowest octave from the monitors would improve the midrange and imaging. In this case, it didn't, interstingly.

I'd sure appreciate whatever thoughts you all have on where to go next.

Howard
aggielaw

Showing 1 response by jamscience

jamscience
95 posts
 

If you have not already ordered the 85Hz modules, it might be beneficial to order a pair of 65Hz modules also. Why? Two reasons:

1) With the 65Hz modules in place, run your speakers first straight from your pre. Then run the signal through the Marchand. There should be little to no difference between the sound you hear (excluding bass, remember the Marchand has a 24db/octive slope vs. your nOrh's natural rolloff). This will tell you if the Marchand is altering your signal in any way. (BTW, do you know if this unit was preassembled and tested vs. a kit?)

2) 65Hz is just under 2 octives below middle C (65.41Hz). Using the Marchand at this crossover point will allow your nOrhs to work their magic to this frequency. Since they normally start their rolloff at this point you can use the Marchand to "bump" the frequency response (+ or-) to smooth out the transition.

Try it with both speakers through the Marchand and see if you can get the sound you want. (be sure to set the crossover on your sub to the highest setting as suggested above (250Hz?). Then try it with just the sub signal going through the Marchand as others have suggested. Be sure to watch your cables as John suggested!

I understand the reasoning behind wanting to eliminate the bottom octive of the main speakers but in your case, the crossover would need to be at 130Hz!

At least you will be able to experiment more if you have at least two crossover points.

Keep us informed of your progress.
More to discover