Here's How I Make My Equipment Racks


In response to a previous thread, here's how I make my
equipment racks:
List of equipment: 3/4" thick MDF cut to desired shelf
size
(4) 3/4" diameter 6' threaded steel rods
3/4" nuts and washers (8 per shelf)
Drill a 3/4" hole in the corner of each shelf in exactly the
same place. I do this by scribing a line with a square 1 1/2" inch in and using a nail set to punch a hole where the lines intersect. A drill press works great to drill the holes so they are all straight and true. Now that you have
a hole drilled in each corner of each shelf, simply screw
the whole thing together, adjusting each shelf to fit your
gear. Use a square to make sure your first shelf is straight, and measure each one likewise. If you do this
correctly, your rack will sit straight and level. If you
need to level it further, buy (4) 3/4 rod connectors, which
are about 3" high, and screw these into the bottom of the
rod and use them to level it. I paint the steel rod using
Krylon Industrial enamel (flat black looks best), and paint
the shelves to match your decor. This makes a very solid,
heavy audio rack. Total cost is about $40 for the steel
rod, $15 for the nuts and washers (about $1.00 a pound)
$20 for the MDF, and $5.00 worth of paint for a total under
$100. I've made several racks this way and have used the
same method to make CD racks.
Dave
Ag insider logo xs@2xdave43

Showing 1 response by cpeay

I've built a similiar rack, but I glued two pieces of 3/4 MDF together to make each shelf 1-1/2" thick and then covered them with cherry veneer (pain in the rear for a novice). I also used 3/4" brass rods (v. steel), brass nuts & brass washers. I got some internally threaded AudioPoints into which the 3/4" brass rods are screwed.

It really made a huge difference in the sound, but it cost me about $500 or so to build the flipping thing and I ended up buying a table saw and a drill press to build it for another $400! I should have just bought a Sistrum Rack.