Help! What's the white glue coming from Celestion SL600SI

Just the sealing compound getting squeezed out, could have been after a very hot day which softened it? If it worries you, undo the tweeter or bass which ever one it's coming from and push it back.

Cheers George 

Don’t hesitate - call Ghostbusters!

Or, do what George suggests.

DeKay

The crossover capacitor blew up and leaked. You probably drove the speaker too hard or an after market capacitor was installed that was not rated enough.

Many large electrolytic caps have white goo in them. You can confirm by opening up your speaker and look for a swollen capacitor. When they explode the goo can go in almost any direction - just like a pin prick leak in a pipe that sprays a couple of feet. I am surprised it leaked out the front - speakers are supposed to be air tight.

https://youtu.be/X6-3hacwFu4

Hi, Thank you for the suggestions. If the capacitor blew up, the speaker/tweeter should have been ruined and muted, right? It is still playing fine. So, maybe we can rule it out.

How challenging is it to take it apart, push the sealing compound back, and still keep the speaker airtight? Any misstep could easily ruin the speaker, I would think.

What if I don't do anything? 

Best,
Shoubang

Any misstep could easily ruin the speaker, I would think.

So long as your not a klutz, it will be fine, and you can reseal with more white silicon if needed.
And it’s only the sealing compound, not any capacitor electrolyte. The white stuff in the video shadorne posted is just white silicon fixing compound to stop things rattling around, and nothing to do with capacitor electrolyte leakage.

Cheers George

@shoubang   

+1 What George said.

I've owned 4 iterations of Celestion SL speakers, and it is easy to remove those 2 front plates with an allen wrench. I have done so many times for different reasons, and I've never seen anything like that. I doubt that it's the crossover. The crossover in these speakers is at the bottom of the box, and it's shielded by thick foam. It might be something that the previous owner put behind the plate for some reason. Screw it off and investigate.  

@shoubang  

Hint   @shoubang , it's only the 4 bigger screws not the 3 smaller inner screw that need to be removed. 
And when you screw them back, just a little nip tight or you'll crack the plastic mounting plate if your a gorilla and crank them down.

Cheers George     

georgehifi,
If you're talking about the ribbed plates on the front baffle, they aren't plastic, they're cast aluminum.

Your right, was it the much cheaper SL6 that was plastic?

http://www.hifirelics.com/starsky10%20pics%2012.28.13/Celestion%20DL6s%20Speakers-A.jpg

Cheers George

@shoubang Did you figure out what the white was?