Scott, @verdantaudio, mentioned it above. Swap components out. Doesn't the Oppo have volume control? Or does it get disabled with the mods? If it still has the volume control remove the preamp and see how it sounds using the Oppo as the "preamp". I find it hard to believe there isn't something else going on with either a component or the speakers so I would sub out preamp first, then amp (if you have anything at all, even an old receiver) then sub the source. I have those Harbeths and have used Pass stuff with them. You could use dental floss as cables and it won't sound as bad as your saying. No way any decent quality cable will make that huge of a difference unless your listening at like 110dB. There's something else going on.
Help. System sounds thin and bright or harsh
Hope this isn't redundant tried to post in Tech Talk
Just moved my system to a new home/sound room and it still sounds harsh and a bit thin despite supposedly "warm" sounding Harbeth 30.1 speakers. This issue is not new and I had put the blame on the old listening room. Can't figure out what the problem is. I listen loud at 80dcbl or higher and sit nearfield about 8 feet from the speaker plane. (sound is thin and bright from afar as well) I have experimented in both homes with speaker placement, toe-in and the like. Speakers are placed a lil over 3 feet from the rear wall and about two and a half feet from side walls. I feel something is off. Perhaps a component or two that is known to be tipped up in the highs and a lil bass shy?? Also, I leave all solid state components fully powered up 24/7. (not the tubes)
System:
Modwright/Oppo BDP 105 disc player (all mods with tubed power supply and pricey NOS tube upgrades throughout) Looking to replace once the harshness/bright issue is nailed down.
Parasound JC2 Preamp
Pass Labs X250.5 Amp
Harbeth 30.1 stand mount speakers
Puritan Labs PSM 156 power conditioner. (less "edgy" sound with it in system)
System is run all balanced with fairly costly Cardas interconnects.
All input is welcome. Thanks in advance.
Happy listening.
Showing 2 responses by bhvf
You could get a pair of SVS 3000 Micro subs for $1700. They have an app for setup and allow phase adjustment from 0-180, rather than REL’s 0 or 180. I’ve found that alone allows for better fine tuning. REL not having an app makes setup frustrating as your constantly getting up to turn dials on the back. I would also trying using the Sumiko setup. It sounds unusual in that your speakers often times don't end up symmetrical but it's all about placing the speakers to your ears and room as no 2 are alike. See here. It's free and you may learn something about placement while doing it. This is how my dealer sets up all his speakers and the only way I do it now. |