Are you using t90a? If so you can use just a cap. 1. -1.5 should work. You might have to try both values buy cheap caps to see. Then replace with dorfs
Help needed for crossover design for supertweeter
Hello out there,
I want to integrate a supertweeter to my altec based 2 way horn speaker. I have a super tweeter already, sensitivity is not a problem it matches within 1db between horn and tweeter. Impedance of the horn and the tweeter are both 8 Ohms. I want the tweeter to run from 10 KHz-open end.
I would need a high-pass with 12? db octave. Any suggestions
for the design? I would like to use mundorf parts.
Thank you in advance for your help. If more information is needed I will give them asap.
I want to integrate a supertweeter to my altec based 2 way horn speaker. I have a super tweeter already, sensitivity is not a problem it matches within 1db between horn and tweeter. Impedance of the horn and the tweeter are both 8 Ohms. I want the tweeter to run from 10 KHz-open end.
I would need a high-pass with 12? db octave. Any suggestions
for the design? I would like to use mundorf parts.
Thank you in advance for your help. If more information is needed I will give them asap.