Help: Audio Gremlins

Hi,

I'm familiar with that sound also. Although I've never had this happen to any of my systems I have isolated this phenomenon twice for other people. One time it was a switch and the other time it was a potentiometer. Just a couple of ideas worth what you paid for them. Also, have you tried switching out the speaker cables? Look closely at the soldering of the terminations. Final thought: have you cleaned the chassis sockets for the tubes? Good luck.

I have the exact same thing with a class D Spectron Musician II amp. I tried a few things to no avail. I'm not very handy with electronics so I couldn't do what Lugnut did with those other amps. I don't even know if an amp with no volume control has a pot. I will look at the solder again.
Things I tried:
Lifted ground
changed speaker cables
tried XLR ic's (worse)
tightened down coil
dedicated lines, P300, Audio Magic Stealth, various pc's

I take the cover off that amp and look and get the same feeling as when I lift my car's hood....unless there is something obviously broken in half, I have no clue.

Patrick

I would suggest making a close inspection of that monoblock's input jack integrity. But first one question: you say you've isolated the problem to the "right monoblock", which leads to me to believe that you may not have tried swapping the two mono's left for right and seeing if the problem follows that amp to the left side or not. I say this because you never know, sometimes these things can be the result of interactions between the components in question, and it still could be originating at the preamp for instance, but not manifesting itself with another model amplifier. Also, before you changed out the tubes, were any of the power tubes found to be unable to bias correctly? A bad tube could have damaged an associated resistor, which wouldn't then be ameliorated by replacing the tube. And last, try swapping (or replacing if you have spares) the output fuse, just in case one may have partially melted rather than blown. But if nothing new is revealed in doing these things, then it sounds like you're probably right in suspecting a passive part failure, though it could be something as mundane and tough to hunt down as a compromised solder joint inside.

I had the same problem with my 3.6s and Cary SLA 70 sig that powers the highs. A static like sound, sort of like a skipping stylus on a record. Tapped on the tubes tops gently until I found the one causing the noise. I tested the tube (E34L) but it was good. I re-seated the tube in the socket several times and the noise never came back. I also rotated the tube in the amp to see if the noise followed the tube. I plan to come up with a way to clean and re-tension the sockets in the near future. You might want to look into this also.