2. analog
  3. 1371127869

Headshell leads and Arche headshell

I just received my Arche headshell. Definitely the best looking headshell that I have ever seen. I have been trying a couple of headshells, Phasetech and Ikeda with my Air Tight and FR64s and I did not like the result all that much in comparison to Reed. However, today, Air Tight with Arche headshell and FR66s sounds very very promising.
However, one problem that I have is headshell leads.
I have Oyaide, Ortofon and Ikeda silver leads that are all quite thick and stiff. I think the lead pins on Arche headshell may be a bit thicker than usual and it was really difficult to insert the headshell leads properly and I broke a few leads in the process :( Took me about an hour to finally fit all 4 leads then I found a new problem. The thick silver leads put enough force on the cartridge and kept pushing down the mounting plate essentially affecting SRA angle. As I understand it, the screw on Arche headshell can push down mounting plate for more SRA but there is no mechanism to fasten the mounting plate tightly against the headshell.
Finally I gave up on using those thick silver leads and just using Sumiko coppper leads for now which is so light and flexible that it virtually exerts no pressure to the mounting plate. Now the Air Tight/Arche/FR66s sounds great but I am wondering if there is any good silver leads that are flexible that would not cause any problem with Arche headshell?
suteetat

Showing 2 responses by peterayer

peterayer
1,382 posts
 
If stiff headshell leads exert enough force to effect and alter the SRA, ie. the movement of the cartridge in the headshell because the mounting plate is on a spring hinge and not fixed, then that seems not to be a very rigid headshell design.

I had been under the impression that a tonearm headshell should be extremely rigid. What is the point of having a rigid arm tube if the headshell is not rigid. Or is this headshell and mounting plate design meant to absorb vibrations by being flexible?

Perhaps I don't understand the design of this headshell.
peterayer
1,382 posts
 
I just got confirmation off line that once SRA is set, one tightens the locking mechanism on the mounting plate and it becomes becomes extremely rigid and a fixed part of the headshell. I guess if the leads exert enough pressure to move the SRA, then one must hold it steady as the locking mechanism is tightened.

Details are on the webpage.
More to discover