Have problem choosing cables XLO or Tara Labs ??

People please give advice ~! I need to order my cable ~! PLEASE HELP

Very simple equippment I have, I shrink everything , I used to have a huge system but I moved into an apartment lately and shrunk my entire system into just a few piece. I have a PS Audio P-600, a Philips SACD1000, and a Marantz PM-17. I used to used all XLO Signature 4.1 & Reference 4a with my Digital Set Up, then MIT MI-350 CVT from my DAC to Marantz. After I changed Philips SACD1000, high became dim, mid became forward, low became slow and boomy, very very thick sounding with a forward soundstage. Thinking that Philips doesn't really make a match with MIT cables... Please help me choose, I need one extreme fast & accurate cable with punchy deep bottom... please help!

I need more help, please keep posting answers for me, still debating...

I have achieved to the best I can do with isolations and power cords. I tried 6 different materials for isolation and a total of 6 power cords.

Isolation I tried:

Isolation Bearings
**Isolation Cone (Alluminum)(Currently using, Best Result)
(Thin down the boomy bass, better focus & accuracy but thinner mid)
**Isolation Cone (Solid Rosewood) (Unbeatable Mid, boomy bass)
**Isolation Platform (Air Pump) (Lowered in accuracy & resolution)
**Isolation Platform (Solid Wood) (No improvement)
**Isolation Stand (Standesign) (Better accuracy & focus)
Isolation Shelf (QS&D) (No improvement)

Power Cords I tried:
**Virtual Dynamics Power 3 (Hi-Freq Roll Off, tight bass)
**XLO Reference 10a (Good silky tuby mid, better hi-freq definition) (Currently Using)
**TekLine PC-8 Signature (Damping factor is high, sound too solid)
**XLO PL1000 (Better bass response than 10a but instructment seperation is not as good)
**NBS DragonFly (No Improvement)
**PS Audio Ultimate Lab (The best, but should use it with the player, double it's cost and eff. ratio not as proportional as XLO 10a)

I have a vpi db-10 on top, it damps it a bit, more seperation and more involving after it was placed.

I currently switch from MIT-MI350 to Van Den Hul, I think the Ind. of MIT doesnt really match, MIT should sound like that but it's now ok with the Van Den HUl. Can be faster and more accurate therefore hunting for XLO & Tara Labs... Advices are greatly welcome!

I always try cheap tweaks with iso. and pc. before I goto an expensive IC upgrade. I have many many toys to play with, and by the way, a lot of them are unuse, s I will be happy to try them out and use them if I could, before I buy any $500 IC.