2. cables
  3. 159036-115039

Guidance on Speaker Wire

I’m looking for guidance on some speaker wires and have tentatively settled in on Transparent High Performance 10-2 with the Transparent 10-2 Brick Network.  My biggest issue is I have long runs from my amps to the speakers at approximately 60 feet each.  Due to size of my system it is not possible to move my equipment any closer to the speakers.  
My amps are 1.2 KWh McIntosh Mono’s and my Speakers are Martin Logan Electrosatic ESL 15A’s. I also have 2 Martin Logan Force 12” subwoofers that are used for home theater. 
Thanks!!
128x128Ag insider logo xs@2xwoots

Showing 2 responses by eagleeye7

eagleeye7
23 posts
 
Looking back, I see that you have some sweet Mono Amps, just figure out how to get them close to the speakers.  If you have a basement, the Amps could go there?
eagleeye7
23 posts
 
I'd recommend that you purchase Mono Amps & place them in close proximity to the speakers.

This would enable you to use SHORT AMPLIFIER Cables (Ideally 3 Ft. or less) & Long Signal Cables, Sound Quality of which are not significantly dependent upon length & can be purchased for a much smaller $$ figure, than Power Cables.

Assuming you are a true Audiophile, this will give you the best SOUND Quality you can get under the circumstances you present.

 
More to discover