granite base for speakers

Great posts! I used 4" slabs of white marble (broken gravestones used as landfill adjacent a quarry near Rutland, VT!) under stands to lift my older two-ways to proper height. (Didn't "deaden" the sound, either!) The increased rez from the bases was a bonus, but of course getting the vertical listening axis correct was more important. No one mentioned the change in bass response as the vertical distance of the woofer to the floor is altered, as well--so remember: even if you raise your sofa on stilts you'll still have a spectrally-altered upper bass/lower mid right? Currently I appreciate that Verity Audio decouples their two-way satellites from the woofer-module bases of my Parsifal Encores via a 1" granite coupling plate, finished with 4 + 4 thin sorbo spots in between, finished by spikes to the floor. I asked them if I should mount the whole system up on these aforementioned marble bases, and they were adamant about not changing either the floor-to-woofer nor mid-to-woofer distances. So I surmise that you: 1) get the woofer height correct first, then 2) dial in your sofa height to perfect the VLA. Then perhaps 3) tilt the speaker a bit forward or back to fine-tune this "voicing", too, but I was also told (again by Verity) that this latter "rocking" is best done lastly to raise or lower the visually-correlated soundstage. (Interestingly, for a tweeter-above-mid/woofer satellite, tilting the speaker forward raised the soundstage, which I found counterintuitive. Live 'n learn!) Good Luck. Ernie

...reread your original post, and wanted to add that the 4" change in VLA completely swamps any effects of power cord changes (esp the "hardening" of the mids). The "diminished" bass is due to the change in woofer height from the floor creating a shift in the floor-bounce null, as well perhaps a spectral-tilt shift due to the altered VLA. The improved imaging is probably due to a combination of the granite indeed, plus perhaps treble-shift due to changed VLA. These shifts are EASILY several dB at several frequencies! So, again, if you want to perform reasonably-good single-blind comparisons with the granite you'll have to somehow NOT alter speaker height while you swap support structures, or your results will be incorrectly deduced. (In my earlier setup with 2-way satellites I learned to correctly compare 20" stands with 4" marble underneath to 24" stands alone; but again, this was AFTER I determined the appropriateness of the 24" total height vis-a-vis my listening height at my unmovable sofa.) So do one thing at a time.... It's only my limited experience, but I suspect that even one inch of VLA change will affect tonal character more than those cords' ripening. Whereas I was limited somewhat by the 4" increment of the marble (WAF!), it seems that stacking these 1" patio slabs mentioned above may be a great way to establish correct speaker height. Maybe you could use 'em under your sofa feet too if woofer-height and/or your leg-length comfort demands it. Have fun! PS If patio block colors don't match your rug you can try cheap bluestone, which is a more neutral light gray.