Got My First Tubes ! What the heck do I do now!?!?! (Nube status)


Howdy. 
So I found a Fisher 800C in lovely condition. "Story goes" that its from a collection but hasn't been used in years. So what the heck do I do now?!? I'm interested in learning but I have to admit I'm far (far) from being an engineer. 
I've heard that step one is to "bring it up" on a variac, while also somehow testing the voltage. Where am I connecting the terminals? I imagine I'm also meant to test all the tubes, but some seen hidden and I wonder if it's best to do this before or after the variac. Also someone put a small sticker on the face. What's the safest thing to clean it with? One of the little gold knob covers fell off. What's the best thing to glue it with? Should I clean the case? 
So as you can see I know next to nothing. My goal is to keep everything as original as possible but I understand folks have opinions on upgrades which are necessary in order to actually preserve the unit. I live in Richmond VA and travel to DC often enough. Does anyone know a well regarded individual of repair shop I should maybe just take it to? What might I expect $ wise? 
I appreciate y'all. My goal is to make this part of a "bedroom system" which I'll post about separately. 
Merci!
seaninatx

Showing 1 response by atmasphere

Fisher made pretty nice stuff but that was a long time ago.


The power supply of the receiver employs things called filter capacitors (round cylinders near the rear of the receiver) that store energy from the power transformer. They are electro-chemical in nature, a bit like a battery but have longer lives but don't store as much energy. For sure at this point they are so old that they *all* need replacing (and they are probably all available from Antique Radio Supply in Arizona).

This will cost $200-$400 to do properly. Its important- if not replaced, they can draw excess current which could destroy the power transformer and that will likely be the end- the transformer is really expensive if you can even find one so you really don't want to allow that. Otherwise the power transformer is plenty reliable.


So get the filter capacitors replaced, deal with the tubes, get the switches and controls cleaned and then see what you think. You'll want to use speakers that are easier to drive and I would avoid 4 ohm speakers as they are far less likely to show off the good properties of the unit that made Fisher famous.