I didn't respond to your question because I'm not familar with your table. However, so long as you can get an armboard cut for the specific arm you want, requirements being a rigid base for the arm, and you can get the correct overhang (distance from spindle to pivot point), you can actually use the any arm you like, so long as it matches your cartridge.
That being said, I strongly recommend you look at the Schroeder. The model 2 which comes with the carbon fibre armwand has an effective mass of 12g and should match most cartridges.
Which cart are you using?
That being said, I strongly recommend you look at the Schroeder. The model 2 which comes with the carbon fibre armwand has an effective mass of 12g and should match most cartridges.
Which cart are you using?