I have the RP10 on a 3/4 birch plywood shelf that's about 24" x 40" and is glued and mitered into the rear and both sides of the component rack. It's pretty solid, but I have some thick rock maple stock around and may elevate the table by a couple of inches with some of that 1/8 or 1/4 thick turntable mat to further reduce vibration. But, mostly it would be just another wood project to make the RP10 look cooler (without the cutout and without the dust cover. Cheers,
Getting the cartridge weight setting right... Rega RP10
So, I have been listening to my Rega RP10 through my Conrad Johnson preamp and amp, and have liked the sound of it quite a bit. Today I received an inexpensive stylus pressure gauge and found that I was at 1.89, which I thought was pretty good for hand measured. Anyway, I reset the weight at the correct 1.75 gram setting. Soundstage immediately became wider and deeper. It sounded like a multi-thousand dollar upgrade. Cost $18.00.
So, for those of you who are wondering if getting the cartridge pressure right-- it matters-- a lot. I am glad i didn't wear out a cartridge prematurely, but am really happy with my $18.00 investment-- Truly, it sounded like I had just dropped $5,000. Happy listening to all.
So, for those of you who are wondering if getting the cartridge pressure right-- it matters-- a lot. I am glad i didn't wear out a cartridge prematurely, but am really happy with my $18.00 investment-- Truly, it sounded like I had just dropped $5,000. Happy listening to all.