Hi I owned an ET for many years. You can make one yourself easily because all you need is a straight line from the centre of the spindle parallel to the "bearing tube". Apart from the set up jig for the ET which gave you the distance to mount the arm, the alignment jig was a piece of acrylic approx 1" by 6" with a spindle hole and scribed line. With the ET you can easily change the angle of the arm and all you do is pivot the whole arm until the cartridge tip runs parallel to the scribed line. Then tighten arm to board and adjust "overhang" until cartridge tip follows the scribed line exactly. For aligning the cartridge the body/canterlever should be dead straight ie a rightangle from the straight line.
4 responses Add your response