Frankly, I'd suspect the speaker since its contribution to the frequency response exceeds that of other components.
The cd player is very unlikely to be the culprit. If you have a spectral balance problem such as recessed bass or treble range, it will make the mids seem prominent. Do you have a db meter and a test cd? The overall frequency response you measure should give you a better clue to as to where the problem lies.
Thanks for the input. I strongly suspected the CD player was not the issue. Both the speakers and Cary SLI-80 are new to the system.
I originally powered the speakers with a Parasound Halo SS amplifier and Sonic Frontiers SFL-1 Pre-amp, but the desire for change got the best of me, and I decided to try tubes for the second time in my 30+ years in this hobby. The speakers also require an amp with a higher output impedance than the typical SS amp, and the tube amplifier did fill in the bass region quite nicely.
I have an L-Pad installed on the XO, but dialing it down takes the life out of the speaker. Is there such a place that you can take a pair of speakers and have them measured, in an anechoic chamber for example, and determine a crossover designe from these measurements?
I have so much time, money and energy in the speakers now, that at this point, I just don't want to give up on them. I feel like I'm one last grasp away from audio nirvana, but it's slippery indeed! 8)
This is the design. A 16 inch driver will start to beam at 1 Khz. This will reduce the lower mid energy. Then as the horn takes over at 1500 Hz you will get some strong upper midrange energy. The horn will then roll off the highs - leaving the impression of strong bass with a pronounced midrange peak.
Since a lot of this is due to the design of the transducer you can't really eq it down and get it to sound right. If you eq it down then it will sound dull. It is partly dispersion and how it loads the room.
I've communicated with other folks that aren't experiencing this effect with their systems, although I believe their XO's are slightly different than mine.
I like the forward nature of the driver, as it really extracts detail beautifully, and it's very lively and "you are there" sounding. I'm sure a good portion of the issue is poor recordings, so I've got a few gremlin's at work here.
I've experimented with placement, but perhaps I should try a few more locations.
Hard to say what's going on with the speakers without a rather comprehensive set of measurements. What you are hearing might be something that can be addressed in the crossover, but some things simply cannot be. Sorry I know that doesn't help much.
You mentioned other people getting good results using a slightly different crossover. In my experience the difference between a good crossover and a lousy one can come down to one dB difference here and there. In my opinion, crossover design (which includes passive equalization of course) is the heart and soul of loudspeaker design. It might well be worthwhile trying that crossover mod that others say sounds better in the midrange.
You can alternatively try a set of XLO reference/signature interconnects (or similar sounding alternatives), which in my opinion, slightly recesses the midrange frequency and can compensate. Also, experiment with hard cones on components and speakers will likely thin out the midrange a bit too.