Isn't the purpose of using the Speltz method the use of solid single copper conductor and not a multi-stranded one?
DIY Anti-IC project
I'm sold on Speltz Anti-Cable and Anti-IC products; they're great. First tried a set of biwire cables for my Magnepan speakers (bought the wire bulk from Speltz @ $1.25 per foot and using in twisted format with no termination), then a 1/2-meter set of Anti-ICs for between preamp & amp (TAD-150 and 60 respectively). Later I decided to install another set of the ICs between CD player and preamp, and inquired about buying the IC wire in bulk form in order to make'em myself (construction of these looked easy enough), but was told this particular gauge of wire is not available for purchase separately.
So, I was on the verge of ordering another 1/2-meter set, then one night while listening had a brainstorm: Why not construct a set of "super" Anti-ICs from the heavier gauge Anti-Cable speaker wire? Since my amp sits on top of the preamp, a 16" pair would be more than enough length, and then I could use the 1/2-meter set I already owned for between CD & preamp. So, I ordered 10' of bulk Anti-Cable from Speltz and (4) Neutrik RCA connectors from Parts Express ($1.75 each). I spiraled the cable around a 3/8" dowel rod, and used a single run of wire through the middle to complete each cable. Upon substitution of my newly-concocted "Anti-IC Plus" interconnects for the standard Speltz version, there was an immediately noticeable improvement in bass depth and impact, along with increased dynamics throughout the range and a bigger and more open sound stage.
I would not have written about this if the difference were less than subtle, in fact, I am one that is not a big believer in "cables can make a difference" (old-school engineering mentality) - But for the cost of $20 for the materials needed to make these interconnects, I urge any DIY'er to give it a shot - You'll like'em. (Email me for a photo of the finished cables if curious.) -Gary
So, I was on the verge of ordering another 1/2-meter set, then one night while listening had a brainstorm: Why not construct a set of "super" Anti-ICs from the heavier gauge Anti-Cable speaker wire? Since my amp sits on top of the preamp, a 16" pair would be more than enough length, and then I could use the 1/2-meter set I already owned for between CD & preamp. So, I ordered 10' of bulk Anti-Cable from Speltz and (4) Neutrik RCA connectors from Parts Express ($1.75 each). I spiraled the cable around a 3/8" dowel rod, and used a single run of wire through the middle to complete each cable. Upon substitution of my newly-concocted "Anti-IC Plus" interconnects for the standard Speltz version, there was an immediately noticeable improvement in bass depth and impact, along with increased dynamics throughout the range and a bigger and more open sound stage.
I would not have written about this if the difference were less than subtle, in fact, I am one that is not a big believer in "cables can make a difference" (old-school engineering mentality) - But for the cost of $20 for the materials needed to make these interconnects, I urge any DIY'er to give it a shot - You'll like'em. (Email me for a photo of the finished cables if curious.) -Gary