I think I think AES stands for Audio Engineering Socity, but I have never seen this listed as a wattage specification. RMS means Root Mean Square, and is used to denote the “average” power indication for sine wave. This value normalizes the wattage to something closer to the DC equivelant value of the AC wave which naturally rises and falls whereas DC would be steady state. Basically shows a more real world comparison value for power output.
- 9 posts total
Ok, AES3 (also known as AES/EBU) is a standard for the exchange of digital audio signals between professional audio devices... AES3 was jointly developed by the Audio Engineering Society (AES) and the European Broadcasting Union (EBU). In laymans terms, AES/EBU connections are 3-pin connections for balanced cables. If you want to read up on balanced vs unbalanced, here is a good article - http://www.clarkeaudio.com/article_balance.htm
The RMS power rating is the measure of continuous power that an amplifier can output, or a speaker can handle. RMS power is derived from Root Mean Square which is a statistical measurement of the magnitude of a varying quantity and is applied to voltage or current.
"AES power" is based on a standard issued by the Audio Engineering Society for characterizing various parameters of speaker drivers, including power handling capability. Here is a link to the first few pages of the standard (there is a charge for non-members to obtain the full document):
Also, the following statement appears at https://www.dasaudio.com/en/f-a-q/power-handling/what-is-aes-power/
The AES (Audio Engineering Society) publishes a standard for the measurement of loudspeaker component parameters. Generally speaking, this standard calls for a 2-hour test using pink noise with specified dynamics and with a frequency content that matches the component`s frequency range. Although it is a standard for components, it is often extended to the different ways on an active system. The rating always derives from RMS voltage or current measurements, therefore the rating corresponds to average (“RMS”) power.
Kijanki is of course correct that strictly speaking average power and RMS power are two different things, although the term RMS power is widely (mis)used to refer to average power.
- 9 posts total