I'll see your three and raise to four (been living in 'Vegas too long...).
Personally, I'd install four lines:
2 for mono blocks
1 Analog
1 Digital
That's all.
Personally, I'd install four lines:
2 for mono blocks
1 Analog
1 Digital
That's all.
Dedicated line help
Finally getting the dedicated line I've always wanted, but had a few questions on how it should be done for best results. My electrician is kinda young and is not an audiophile (the flipside is he's only charging 75 bucks to do it), so I'm relying on you guys for the details.
Some general info in case it's helpful: The system is in the basement and in the same room as the circuit box about 30 feet away. The wire will be fished behind the walls that fortunately have a few access panels between the box and my system, and there is no insulation between the wall and the foundation -- just some heat pipes (steam heat).
Questions:
Is 20amp strongly preferable over 15amp line or does it not matter that much? I'm currently running a 125wpc push/pull solid state amp but may very well run something like a 100wpc class A ss amp in the future, if this makes a difference.
I'm going to purchase a Porter Port, but is there certain type/brand of wire that should be used from the circuit box to the Port or will the standard stuff do fine?
Should I have him run 2 lines -- one for analog and one for digital, or is there another way to separate these guys (or is it sufficient just to do this at the power conditioner, which I don't have yet)?
Anything this guy could do wrong that could cause problems or create a fire hazard?
Any other tips you guys have either on the installation or equipment would be most appreciated. THANKS FOR ANY THOUGHTS/HELP.
Some general info in case it's helpful: The system is in the basement and in the same room as the circuit box about 30 feet away. The wire will be fished behind the walls that fortunately have a few access panels between the box and my system, and there is no insulation between the wall and the foundation -- just some heat pipes (steam heat).
Questions:
Is 20amp strongly preferable over 15amp line or does it not matter that much? I'm currently running a 125wpc push/pull solid state amp but may very well run something like a 100wpc class A ss amp in the future, if this makes a difference.
I'm going to purchase a Porter Port, but is there certain type/brand of wire that should be used from the circuit box to the Port or will the standard stuff do fine?
Should I have him run 2 lines -- one for analog and one for digital, or is there another way to separate these guys (or is it sufficient just to do this at the power conditioner, which I don't have yet)?
Anything this guy could do wrong that could cause problems or create a fire hazard?
Any other tips you guys have either on the installation or equipment would be most appreciated. THANKS FOR ANY THOUGHTS/HELP.